Response SL5 Manuel d'instructions télécharger pdf (Page 52)

Double Dial-In for Operation with an External

Answer Phone:

If the Remote Access and Control feature is to be

used and the system is operating in conjunction with

an external Answer Phone then

1. Remote Phone Access and Control must be

enabled.

2. The number of ‘rings to answer’ for the Control

Panel must be greater than that of the external

answerphone.

To access the Remote System Control facility the

Control panel has a ‘double dial-in’ feature to enable

the Control Panel to pick-up the phone call before the

external answerphone cuts in. The ‘double dial-in’

procedure operates as follows:

1. Dial up the system and hang up after 1 or 2 rings.

2. Wait a few seconds and then redial up the system

within 20 seconds, the system will answer the

phone after 1 ring.

3. Enter the User Access Code as described above.

Remote Access and Control Functions:

The following functions may be access via the

remote telephone. The system will acknowledge

each signal with a single long beep over the phone.

Press to interrogate the system status.

The status will be indicated by the following

tones which are generated once.

1 long beep system Disarmed

1 short beep system Armed

2 short beeps system Part-Armed (1 or 2)

3 short beeps Alarm has occurred

Press to initiate FULL ARM mode.

Press to initiate Part-Arm 1 mode.

Press to initiate Part-Arm 2 mode.

Press to Disarm the system.

Press to turn the Siren OFF.

Press to turn the Siren ON.

Press to activate listen in.

Press to stop Listen-In.

Press to end the session and disconnect

the Control Panel line.

MONITORING (OPTIONAL)

REMOTE MANAGER

Refer to Remote Manager diagram on page 53.

If an alarm occurs and the Remote Manager dialler

is enabled…

1. The Remote Manager dialler will activate after

fixed 30s dialler delay has expired provided the

system has not been disarmed in that period.

2. The first Remote Manager phone number will be

dialled and the appropriate alarm signal transmitted.

3. If an acknowledgement signal is received from

the Alarm Monitoring Service the dialler will stop

and an ‘R-Manager Send OK’ message will be

entered into the event log.

However…

4. If an acknowledgement signal is not received

from the Alarm Monitoring Service the call will

be ended and the next number will be dialled.

There will be a 10s pause between consecutive

calls in the same sequence and a 30s pause

between consecutive sequences.

5. If an acknowledgement signal is not received after

each entered number has been called three times

then the dialler will shut down and an ‘R-Manager

Fail’ message will be entered into the event log.

Notes:

1. If system disarmed while dialler is operating the

current call should be completed. After a further

10s the dialler will operate and send a Cancel

signal to the alarm monitoring service using the

same dialler process described above.

2. The same alarm event signal must not be re-

transmitted until there has been at least 10

minutes of inactivity of that event. Alarm events

on different zones are treated separately.

For example:

If an alarm event is triggered by a detector

on zone 1, the AMS will be contacted with a

“zone 1 intruder signal”.

If another zone 1 alarm event occurs within

10 minutes the AMS will not be contacted

with this event. The 10 minute period should

restart at this point.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 63 64

Commentaires sur ces manuels

Pas de commentaire

Response SL5 Manuel d'instructions Page 52

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Response SL5