Response SL5 Manuel d'instructions télécharger pdf (Page 23)

15. Now scoll through the menu again until ‘Wirefree

Siren Service OFF’ is displayed and press .

The Siren will produce a single long beep

followed by two short beeps.

16. Do not exit Test Mode at this stage. Now test the

Wireless Siren prior to installing it on the wall.

(See step 17 below).

TESTING THE WIRELESS SOLAR SIREN

Enter Test Mode if not already in (see page 13).

17. Use the and buttons to scroll through

the menu until ‘Wirefree Siren Test’ is displayed

and press .

During the test the LCD will display:

18. The Siren will activate for 5 seconds to show it is

working. Now follow the instructions below to

mount the Solar Siren on to the wall.

MOUNTING THE SOLAR SIREN ON

TO THE WALL

Prior to mounting the Siren, the Siren needs to be

placed into Service mode again else pressing the

Siren’s Tamper Switch against the wall will trigger

the Siren.

19. Scroll through the Test Mode menu using the

and buttons until ‘Wirefree Siren

Service ON’ is displayed and press .

The Siren will produce two short beeps followed

by one long beep.

20. Hold the clear plastic mounting template

supplied in position on the wall and mark the

positions of the four mounting holes. A spirit

level placed on the top edge will help ensure you

get the unit level.

21. Undo the fixing screw securing the mounting

plate from the bottom edge of the siren and

remove the plate.

22. Drill four 6mm holes and fit the wall plugs.

23. Fit the two 30mm fixing screws in the top holes

leaving approximately 9mm of the screw protruding

24. Fit the keyhole slots in the top of the siren over

these screws and check that they form a neat fit

with minimal movement. If necessary remove

the siren and adjust the screws as required.

25. Remove the siren and fit the wall mounting plate

in position using the two 25mm fixing screws.

26. Fit the siren to the wall ensuring that the keyhole

slots are correctly fitted over the heads of the

two top fixing screws and the lower fixing hole

lines up with the wall plate.

27. Secure the Siren in place by fitting the lower

fixing screw in the wall plate. Do not over-tighten

the screw as this could damage the thread.

28. Now switch the Siren out of service mode. In

the Test Menu, select ‘Wirefree Service OFF’

again and press .

The Siren will produce a single long beep

followed by two short beeps.

29. Press to exit Test Mode and return the

system to Operating Mode.

the Indicator/Learn LEDs will start flashing

together rapidly, (once every second).

After 10s the ‘Siren Stop’ signal will automatically

be retransmitted by the Control Panel for the siren

to confirm the control panels ID code.

The siren will produce single long beep and

the Indicator/Learn LEDs will stop flashing

and remain ON for 3 seconds after which it

will go out to indicate that the Control Panel is

now linked to the Siren and its ID code

recorded in memory.

ENTER

Siren ON for 5s

Stop->ESC

IMPORTANT:

The Siren must now be left in

position for a

t least 24 hours to fully

charge the Main Battery before

testing or operating the alarm.

ESC

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 63 64

Commentaires sur ces manuels

Pas de commentaire

Response SL5 Manuel d'instructions Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Response SL5