Response SA1 E Instructions d'exploitation

Installation & Operating ManualSA1, SA2, SA2PFWirefree Alarm System1470285 693LOW BATT.ON AIR21

10When deciding upon the mounting position for the detector the following points should be considered to ensure trouble free operation:1. Do not posit

118. To select the required sensitivity, set DIP switch 5 of SW3 as follows:ON = HIGH sensitivityOFF= LOW sensitivityNote: The recommended setting is

12CR2032 type Lithium cells which under normal conditions will have an expected life of approximately 1 year. Under normal battery conditions the LED

134. If an additional wired Magnetic Contact is required, this should be wired to the terminal block provided in the battery compartment. The wired c

14The Siren is powered by a rechargeable sealed lead acid battery. A solar panel mounted on the top of the housing charges the battery during dayligh

15INSTALLING AND CONFIGURING THE SIREN1. Remove the xing screw from the bottom edge of the Siren housing and carefully hinge off the front co

162. Press the tamper switch, both indicator LEDs will ash together several times. The LED’s will then continue to ash alternately every 10 seconds

17If your system includes PIR Detectors:8. Arm the system in Instant-Arm mode by pressing on the Remote Control.The Siren will acknowl

18ARMING THE SYSTEM IN INSTANT-ARM MODEThe system can be Armed in Instant mode by using either the Remote Control or the Keypad as follow

19SIREN SERVICE MODEIn order to remove the Siren from the wall to change the batteries, it is necessary to place the Siren into Service Mode to preven

2FOREWORDAll devices in these wirefree alarm systems are designed and manufactured to provide a high standard of security protection and long, reliabl

20MAINTENANCEYour alarm system requires very little maintenance. However, a few simple tasks will ensure its continued reliability and operation.IMPO

21ALARM RECORDYou may make a note of your User Access Code and System House Code below.User Access Code System House CodeUse the above diagram to reco

22PIR Movement Detector false alarming.1. Ensure that the detector is not pointing at a source of heat or a moving object.2. Ensure that the detecto

23The following additional accessories are available to enhance your system and provide further protection and a higher level of security where requir

Magnetic Contact Detector(s)• RF operating frequency: 433MHz• Range: 75 metres max.• Test Mode• Anti-Tamper protection• Facility to connect additional

3CONTENTSKIT CONTENTS 4INTRODUCTION AND OVERVIEW 5System Arming 5Entry/Exit Delay 5Alarm Lockou

4KIT CONTENTSThe Alarm System should contain the following devices.Alarm System SA1 SA2 SA2PFSolar Siren 1 1 1Remot

5SYSTEM ARMINGThe system has an Instant-Arm and Delay-Arm mode.If the system is armed in Instant-Arm mode then all detectors will immediately become f

6Before attempting to install your alarm system it is important to study your security requirements and plan your installation.PIR Movement Detectors

7The Remote Control Unit is used to Arm in either Instant-Arm or Delay-Arm modes and to Disarm the system.The Remote Control Unit also incorporates a

81. Undo and remove the xing screw from the bottom edge of the Keypad and remove the wall mounting plate.2. Using the mounting plate as a template, m

9CHANGING THE USER ACCESS CODEWhen using the Keypad the keys must be pressed rmly and within 3 seconds of each other. If you make a mistake, wait 15