Response SA2 E Instructions d'exploitation

Installation & OperatingManualSA1/SA2/SAC1WirefreeAlarm Systems1470285693LOW BATT.ON AIR21

POSITIONING THE KEYPADThe Keypad is suitable for mounting in dry interiorlocations only.The Keypad should be located within a protectedarea so that an

does not flash, wait five seconds and re-enter theprogramming sequence from the beginning.TESTING THE KEYPAD1. Put the system into Operating mode by p

Detection Zone Pattern for PCB in position 5When considering and deciding upon the mountingposition for the detector the following points shouldbe con

To adjust the PCB position simply slide it up anddown ensuring that the location legs are alignedwith the required position number marked on theboard.

3. Reconfigure the PIR Detector into Normaloperation mode and refit in position.Note: When the detector is fully installed i.e. batterycover is refit

When fixing the Detector with screws the top ofthe Detector is secured with a keyhole slot over thehead of the smaller pan head screw. The bottomof t

TESTING THE SYSTEMINITIAL TESTINGAs the system is initially installed it is recommendedthat each device is tested in turn as it is installed, (referto

immediately generate a Full Alarm condition. On returning to and entering the property the system mustbe Disarmed before opening any protected door o

PERSONAL ATTACK (PA) ALARMA full alarm condition can be immediately initiated bythe user at any time (whether the system is armed ordisarmed) in the e

battery charge. Failure to maintain charge to theunit will result in the rechargeable battery runningunacceptably low. Should this occur, the unit m

FOREWORDThe SA1, SA2 and SAC1 Wirefree Alarm Systems complywith the requirements of BS6799 Class 1 for WirelessAlarms. All components are designed an

TROUBLE SHOOTINGSiren gives full alarm condition when arming.1.Siren anti-tamper switch activated - adjust tamperplunger and ensure that switch fully

TROUBLE SHOOTING - continuedMagnetic Contact Detector not working.1.Ensure batteries are connected with correct polarity.2.Ensure battery connections

EXTENDING YOUR ALARM SYSTEMYour system may be extended to provide additional protection by adding additional PIR Movement Detectors, MagneticContact S

ResponseSA1/SA2/SAC1 Wirefree Alarm SystemsIf you have a problem with your Alarm, please call the Helpline on:01268 563273(Lines open 9.00am to 5.00pm

45170PL Ed.1Response, Novar Electrical Devices and Systems. The Arnold Centre, Paycocke Road, Basildon, Essex. SS14 3EA.Novar Electrical Devices and

CONTENTSPage No.KIT CONTENTS 2PLANNING AND EXTENDING YOUR WIREFREESOLAR ALARM SYSTEM 3EXTERNAL SOLAR SIREN 4General Information 4Positioning the Solar

KIT CONTENTSThe Alarm System should contain the followingcomponents.Alarm SystemSA1 SA2 SAC1External Solar Siren Controller 1 1 1Remote Control 1 1 1P

The following example below shows typical propertyincorporating the suggested positions for the ExternalSiren, Keypad, PIR and Magnetic Detectors for

EXTERNAL SOLAR SIRENThe Siren and Solar Panel are all encapsulated within atough polycarbonate housing. This housing provides fullprotection against

CONFIGURING THE SOLAR SIRENEnsure that the Solar Siren main configuration switchon the LED strobe board is set to "C.U." for use withthis al

INITIAL POWER-UP OF THE SOLAR SIREN1. Connect the 9V PP3 initial power battery to thebattery clip.Connect the rechargeable battery to the charginglead

5. Replace the rear cover and fixing screw.TESTING THE REMOTE CONTROL1. Stand within view of the Solar Siren, press and holdthe ‘INSTANT-ARM’ button o