Response SL5 Manuel d'instructions télécharger pdf (Page 19)

6. Switch SW3 is used to enable/disable the

internal/external wired magnetic contact.

Position of SW3 Function

INT. Internal Contact ON

INT./EXT. Internal and External

Contacts ON

7. Set the Door/Window Detector by setting the

position of the switch (SW3).

If setting to the INT. position, only the internal

contact will be active. When two contacts are in

use for internal and external connection

simultaneously (INT./EXT. position), only one

activation will be counted if one of the contacts is

opened. If one contact is left open and the other

closed contact is opened then an activation will

be counted.

If using external contacts wired to the Detector,

set to the INT./EXT. position.

8. Refit the battery cover.

TESTING A MAGNETIC DOOR/WINDOW

DETECTOR INDEPENDENTLY

Remove battery cover to activate the tamper switch.

As the button is released the LED indicator will

illuminate for approximately 1 second to show

that the tamper switch has been triggered and a

signal is being transmitted.

10. Open the door/window to remove the Magnet

from the Detector.

As the Magnet is moved away from the Detector

the LED indicator will illuminate for

approximately 1 second to show that the

Detector has been triggered and a signal is

being transmitted.

Note: It does not matter if the LED indicator

illuminates as the magnet is brought towards

the detector.

LINKING A MAGNETIC DOOR/WINDOW

DETECTOR TO THE CONTROL PANEL

1. Remove the battery cover after installing and

configuring it.

With the system in Standby

Press

to enter Program Mode.

3. Scroll through the programming menu until

‘3. ZONE SETUP’ is displayed and press .

Enter the zone number to be configured (1 - 36)

and press .

Note: Zones 33-36 the wired zones are the

same except there is no learn menu option as

these are wired.

5. To learn a new detector ID code and link it to the

selected zone

press .

The panel will now listen for a valid signal from

a new detector to link to the zone.

The Panel will remain in Learn Mode for 30s.

If a valid signal is not received from a new

detector within 30s it will automatically exit

Learn Mode and return to the top of level 3.1

Location of

Key-hole Screw

(underside)

Hole for

Mounting

Screw

Terminal Block for

Additional Wired

Magnetic Contact

Tamper

Switch

8mm

11mm

SW3

Switch

SW3

INT.

INT./EXT.

Switch SW3

INT./EXT. Position

Switch SW3

INT. Position

SW3

INT.

INT./EXT.

SW3

INT.

INT./EXT.

IMPORTANT:

If not using external contacts,

set to the INT. position for the Detector to

operate correctly.

ENTER

, ,

Installer Access Code

ENTER

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 63 64

Commentaires sur ces manuels

Pas de commentaire

Response SL5 Manuel d'instructions Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Response SL5