Response SA5 E Instructions d'exploitation Page 27
- Page / 52
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
27
The parameters in this menu allow the conguration
of general system parameters, such as the Control
Panel House Code, Alarm Duration and control of
any hardwired or output relay alarm contacts. This
section also contains the basic setup information for
the systems telephone dialler interface which must be
congured appropriately if any of the telephone based
functionality is to be used.
Scroll through the top level programming menu until
‘2. SYSTEM SETUP’ is displayed and press .
Note: After completing the system setup press to
return to the top level programming menu.
LEARN SYSTEM HOUSE CODE
Scroll through the menu until ‘2-1 Learn House Code’
is displayed.
To change the setting press .
The current House Code setting will be displayed.
The new system House Code can be programmed
either directly at the Control Panel or via a Remote
Control Unit.
At the Control Panel:
Press buttons 1-8 on the Control Panel to
congure the display to the correct house
code setting. As each button is pressed the
corresponding digit in the code will change to
the opposite state, (“0” or “1”).
1 = House Code DIP Switch On/Up
0 = House Code DIP Switch Off/Down
Using a Remote Control:
With the required House Code already
congured, press the button on the
Remote Control.
When the Control Panel receives the signal
from the Remote Control the Panel will beep
and the display will change to show the
received House Code on lower line of the
display beneath the corresponding DIP switch
numbers (1-8).
Press to save the new setting, or
Press to exit without saving.
Note: Make a note of the System House Code in the
Alarm Record section.
ALARM DURATION
Scroll through the menu until ‘2-2 ALARM TIME’ (and
the current setting) is displayed.
To change the settings press .
On/Off Status
Default setting: ON
SYSTEM SETUP
- 6 Zone Communicating 1
- Wirefree Alarm System 1
- Tools and Equipment Required: 2
- CONTENTS 3
- KIT CONTENTS 4
- INTRODUCTION AND OVERVIEW 5
- button on their 6
- 7
- 7
- 7
- TYPICAL INSTALLATION 8
- REMOTE CONTROL UNIT 9
- Testing the Remote Control: 10
- INSTALLING THE CONTROL PANEL 11
- Inside View of Control Panel 11
- At the Control Panel: 12
- Using a Remote Control: 12
- PASSIVE INFRA RED (PIR) 13
- MOVEMENT DETECTORS 13
- PIR DETECTOR 14
- Testing the PIR Detector: 15
- 1 2 3 4 5 15
- MAGNETIC CONTACT 16
- DETECTORS 16
- + side is uppermost on each 17
- EXTERNAL SOLAR SIREN 18
- SOLAR SIREN 19
- . 20
- User Access Code 21
- FACTORY SETTINGS 23
- Master User Access Code 24
- LEARN SYSTEM HOUSE CODE 27
- ALARM DURATION 27
- to save and exit, or 28
- RINGS TO ANSWER PHONE 29
- DIALLER DELAY 29
- DIAL METHOD 29
- DIAL MODE 29
- ZONE SETUP 30
- FINAL EXIT SET 31
- ENTRY DELAY 31
- Delay Period 31
- PART-ARM 1 32
- PART-ARM 2 32
- WALK THROUGH 32
- TELEPHONE NUMBERS 33
- ALARM MESSAGE PLAY TIME 34
- RECORD ALARM MESSAGES 34
- REPLAY ALARM MESSAGES 34
- CALL ROUTING 34
- TEL CONFIRM TIMES 34
- EXIT-DELAY PERIOD 35
- ENTRY-DELAY BEEPS 35
- EXIT-DELAY BEEPS 35
- CALL ATTEMPTS 35
- TIME & DATE SETUP 38
- LATCH KEY SETUP 38
- 39
- ANSWERPHONE ON/OFF STATUS 39
- TELEPHONE NUMBER: 40
- REPLAY ANSWERPHONE GREETING 40
- OPERATING INSTRUCTIONS 41
- LEAVING A VOICE MEMO MESSAGE 43
- External Answerphone: 43
- Control Panel 45
- Remote Control 45
- PIR Movement Detector 45
- Magnetic Contact Detector 45
- MAINTENANCE 46
- ALARM RECORD 47
- Symptom / Recommendation 48
- EXTENDING YOUR ALARM SYSTEM 50
- GUARANTEE 50
- 01268 563273 52
Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Response SA5 E
(24 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.037 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels