Response SA5 E Instructions d'exploitation Page 21
- Page / 52
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
21
TESTING THE SYSTEM
The Control Panel has a built in test facility to enable
you to test the system at any time. However it is
recommended that the system is tested at regular
intervals not exceeding 3 months.
The Control Unit incorporates a terminal block for
connection of hard-wired zones (7-10) and a wired
Siren unit. The connection terminal block is located
inside the Control Panel behind the front cover. To
access the terminal block you must rst put the system
into Test Mode to prevent an alarm occurring.
To do this:
Press
Undo the two xing screws on the top edge of the
Control Panel and open the front cover.
Before making any connections, ensure that the Reset
Jumper Link P1 is in the ’OFF’ position and then
remove the DC power jack and disconnect 1 of the
back-up batteries.
The hardwired zone and tamper switches should be
volt free and normally closed, with the contacts opening
in order to trigger an alarm.
Note: Jumper Link P51 should be tted into the ON
position only if the external hardwired tamper circuit is
used, otherwise it must be in the OFF position.
After making your external connections reconnect the
power supply and Back-up Battery. Then close the
Control Panel cover and tighten the screws on the top
edge of the Control Panel.
Press to leave Test mode and return to Standby.
With the system in Standby press
The Arm and Part-Arm LEDs will ash.
The system is now in Test Mode.
Use the and buttons to scroll through the
menu and press to select the displayed test
function or sub-menu.
Note: After completing all required test functions press
to leave Test Mode and return to Standby.
DETECTOR TEST
Before commencing testing please ensure that there
is no movement in any PIR protected area, all doors/
windows protected by Magnetic Contact Detectors are
closed and that all battery covers and housings are
correctly tted.
Note: It may be helpful to have a 2
nd
person to assist
with this test.
press ENTER
Relay Test
Replay ON for 5s
Stop->ESC
Wirefree Siren
Test
Hardwired Siren
Test
WALK TEST
TEST MODE
Code:
Voice Dialler
Test
Test phone No._
Stop->ESC
Remote Manager
Test
ALARM TEST
Walk Test
Waiting…
Wirefree Siren
Service ON/OFF
Service ON/OFF
Wait for 10s
press ENTER
press ENTER press ENTER press ENTER
press ENTER
press ENTER press ENTER
Siren ON for 5s
Stop->ESC
Siren ON for 5s
Stop->ESC
Remote Manager
Test…wait
, ,
User Access Code
, ,
User Access Code
- 6 Zone Communicating 1
- Wirefree Alarm System 1
- Tools and Equipment Required: 2
- CONTENTS 3
- KIT CONTENTS 4
- INTRODUCTION AND OVERVIEW 5
- button on their 6
- 7
- 7
- 7
- TYPICAL INSTALLATION 8
- REMOTE CONTROL UNIT 9
- Testing the Remote Control: 10
- INSTALLING THE CONTROL PANEL 11
- Inside View of Control Panel 11
- At the Control Panel: 12
- Using a Remote Control: 12
- PASSIVE INFRA RED (PIR) 13
- MOVEMENT DETECTORS 13
- PIR DETECTOR 14
- Testing the PIR Detector: 15
- 1 2 3 4 5 15
- MAGNETIC CONTACT 16
- DETECTORS 16
- + side is uppermost on each 17
- EXTERNAL SOLAR SIREN 18
- SOLAR SIREN 19
- . 20
- User Access Code 21
- FACTORY SETTINGS 23
- Master User Access Code 24
- LEARN SYSTEM HOUSE CODE 27
- ALARM DURATION 27
- to save and exit, or 28
- RINGS TO ANSWER PHONE 29
- DIALLER DELAY 29
- DIAL METHOD 29
- DIAL MODE 29
- ZONE SETUP 30
- FINAL EXIT SET 31
- ENTRY DELAY 31
- Delay Period 31
- PART-ARM 1 32
- PART-ARM 2 32
- WALK THROUGH 32
- TELEPHONE NUMBERS 33
- ALARM MESSAGE PLAY TIME 34
- RECORD ALARM MESSAGES 34
- REPLAY ALARM MESSAGES 34
- CALL ROUTING 34
- TEL CONFIRM TIMES 34
- EXIT-DELAY PERIOD 35
- ENTRY-DELAY BEEPS 35
- EXIT-DELAY BEEPS 35
- CALL ATTEMPTS 35
- TIME & DATE SETUP 38
- LATCH KEY SETUP 38
- 39
- ANSWERPHONE ON/OFF STATUS 39
- TELEPHONE NUMBER: 40
- REPLAY ANSWERPHONE GREETING 40
- OPERATING INSTRUCTIONS 41
- LEAVING A VOICE MEMO MESSAGE 43
- External Answerphone: 43
- Control Panel 45
- Remote Control 45
- PIR Movement Detector 45
- Magnetic Contact Detector 45
- MAINTENANCE 46
- ALARM RECORD 47
- Symptom / Recommendation 48
- EXTENDING YOUR ALARM SYSTEM 50
- GUARANTEE 50
- 01268 563273 52
Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Response SA5 E
(24 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.091 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels