Response SL8 Manuel d'instructions télécharger pdf (Page 26)

With the system in Standby (i.e. with the Power LED

ON)

ress

ote: To get to Standby Mode simply press

epeatedly until only the POWER LED is illuminated.

he Arm and Part-Arm LEDs will illuminate and all

Zone, Fire and tamper LEDs will flash together.

The system is now in Program Mode.

Note: After programming all required functions

press to leave Program Mode and return to

Standby.

USER ACCESS CODE

This allows the 4 digit User Access code to be

changed to your own unique code which only you

and other system users should be aware off.

Default setting: 1 2 3 4

To change the setting press

Zone LEDs 1-4 will illuminate.

Enter the new 4 digit User Access Code. As

each digit is entered, an illuminated zone LED

will be turned OFF.

Press to

save the new setting and exit to

Program Mode, or

Press to exit without saving

ALARM DURATION

This allows the alarm duration period (of the Control

Panel, Solar Siren and Hardwired Siren) to be set as

you require.

Note: Following initiation of a Full Alarm, the Siren

will continue to sound until either the system is

Disarmed or the Alarm Duration Time expires.

However, if the ‘3 minute alarm time limit’ of the

Solar Siren is enabled then the Solar Siren will shut

down after 3 minutes even if the Control Panel siren

is still operating.

Default setting: 3 minutes

Press

The zone LED corresponding to the current

setting will illuminate.

0 no alarm

1 minute

2 2 minutes

3 3 minutes

4 5 minutes

5 10 minutes

To change the setting:

Press the button corresponding to the required

alarm period, the corresponding zone LED will

illuminate as the setting is changed.

Note: When set to ‘No alarm’ the Siren will

sound for approximately 10 seconds if an alarm

condition is triggered.

Press to

save the new setting and exit to

Program Mode, or

Press to exit without saving

ENTRY/EXIT DELAY

This allows the entry/exit delay period applied to

‘Delayed’ zones to be configured and/or changed.

This has no effect on zones configured to ‘Instant’.

Default setting: 30 seconds

Press

The zone LED corresponding to the current

setting will illuminate.

1 10 seconds

2 20 seconds

3 30 seconds

4 40 seconds

5 50 seconds

6 60 seconds

To change the setting:

Press the button corresponding to the required

delay setting, the corresponding zone LED will

illuminate as the setting is changed.

PROGRAMMING INSTRUCTIONS

NTER

User Access Code

ESC

ENTER

ESC

ENTER

ESC

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Response SL8 Manuel d'instructions Page 26

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Response SL8