Response SL5 Instructions d'exploitation télécharger pdf (Page 21)

INSTALLATION

POWER-UP OF THE SOLAR SIREN

1. Connect the 9V PP3 initial power battery to the

battery clip.

Connect the rechargeable battery to the charging

leads. Connect the Red lead to the Red (+ve)

terminal and the Black lead the Black (

ve)

terminals. Both indicator LEDs will flash together

in a single long flash to indicate that the unit is

operational.

Important: Once the batteries have been

connected, the Siren will be operational. It is

important that the solar panel receives sufficient

light to maintain the battery charge.

2. Press the anti tamper switch, both indicator LEDs

will flash together four times.

3. Hinge the front cover locating tabs over the top

edge of the back plate and carefully push the base

of the siren cover into place. Secure the Siren

cover in place by refitting the fixing screw in the

bottom edge of the cover. Do not over tighten the

screw as this could damage the thread.

Important: Ensure that the rear tamper switch is

closed when you fit the siren cover to the back-

plate (i.e. listen for the switch to click). If the switch

does not close this will prevent the Solar Siren from

operating correctly. If necessary, remove the siren

cover again and adjust the screw on the back-

plate tamper plunger to ensure the switch closes

when the Siren is secured in position.

4. If fitted remove the protective film covering the

Solar Panel.

TESTING THE SOLAR SIREN

Ensure that the system is in Test mode (see page 20).

Scroll through the top level Test Mode menu until

‘ALARM TEST’ is displayed and press .

Scroll through the menu until ‘Wirefree Siren Test’

is displayed and press .

3. The Solar Siren should operate for a period of

approximately 5s,

4. Press to exit Alarm Test and return to the

top level Test Mode menu.

EXTERNAL CONNECTIONS

The Control Unit incorporates a terminal block for

connection of hard-wired Zones (7-10) and a wired Siren.

The connection terminal block is located inside the

Control Panel behind the front cover.

To access the

terminal block:

Press , ,

This puts the system into Test Mode and prevents an

alarm occurring.

Undo the two fixing screws on the top edge of the

Control Panel and open the front cover.

Before making any connections, ensure that the

memory jumper link P1 is in the ’OFF’ position and

3 4

ENTER

T1 T2 GND T3 T4 N.C. CN.O.GNDGNDTAMP GND B+ V+ OUT GND

Permanent

12Vdc power

supply output

(100mA max.)

Latching

relay contacts

(Volt-free)

Hardwired Zone

Connections

(Using

Normally-Closed

contacts)

Switched

12Vdc output for

wired Siren

(300mA max.)

GND

N.C.

N.O.

GND

TAMP

GND

B+

V+

OUT

GND

Tam per circuit

connections for

wired Siren

Not Used

Terminal

Block

Reset

Jumper

Link P1

Terminal Block Detail

External Tamper Switch

Jumper Link P51

SA5 19

The Siren should not be operated repeatedly

during installation and testing, as this will

rapidly drain the battery. It is recommended

that the Siren be left for at least 24 hours in

order to charge the battery before the system

is Armed.

ENTER

ESC

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Response SL5 Instructions d'exploitation Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Response SL5