Response SL2 Instructions d'exploitation télécharger pdf (Page 17)

The Detector and Magnet should be mounted

using the double sided adhesive pads or screws

provided.

Note: If mounting the device using the adhesive

pads, ensure that the mounting surfaces are

clean and dry before mounting.

If fixing the detector with screws first remove

the battery holder by carefully tilting up the

end and pulling away from the printed circuit

board (PCB).

The top of the Detector is secured by hanging

the keyhole slot over the head of the 10mm pan

head screw. The bottom of the Detector is

secured using the 12mm counter-sunk head

screw fitted within the battery compartment.

Carefully drill out the centre of the fixing screw

hole in the battery compartment using a 3mm

drill. Fit the Magnet using the two 15mm fixing

screws. Do not over- tighten the screws as this

may distort or damage the casing.

5. If an additional wired

Door/Window

is required,

this should be wired to the terminal block

provided in the battery compartment.

The wired contact should be connected using

a maximum length of 1.5 metres of any of

the following:

–

6 core alarm cable

–

2 core bell wire (6 x 0.2mm minimum)

–

2 core 24AWG wire

A cable entry cut-out is provided beside the

terminal block in the battery cover.

6. Switch SW3 is used to enable/disable the

internal/external wired magnetic contact.

Position of SW3 Function

INT. Internal Contact ON

INT./EXT. Internal and External

Contacts ON

7. Set the

Door/Window

Detector by setting the

position of the switch (SW3).

If setting to the INT. position, only the internal

contact will be active. When two contacts are in

use for internal and external connection

simultaneously (INT./EXT. position), only one

activation will be counted if one of the contacts

is opened. If one contact is left open and the

other closed contact is opened then an

activation will be counted.

If using external contacts wired to the Detector,

set to the INT./EXT. position.

8. Refit the battery cover.

Detector

Magnet

Alternative

Mountings

Location of

Key-hole Screw

(underside)

Hole for

Mounting

Screw

Terminal Block for

Additional Wired

Magnetic Contact

Tamper

Switch

8mm

11mm

SW3

Switch

SW3

INT.

INT./EXT.

Switch SW3

INT./EXT. Position

Switch SW3

INT. Position

SW3

INT.

INT./EXT.

SW3

INT.

INT./EXT.

IMPORTANT:

If not using external contacts,

set to the INT. position for the Detector to

operate correctly.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Response SL2 Instructions d'exploitation Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Response SL2