Response SA5 E Instructions d'exploitation télécharger pdf (Page 21)

Reset Factory Default Conditions

1. Press

to place the system in Test Mode.

2. Undo the Control Panel cover fixing screws and

open the cover.

3. S

witch OFF the mains supply to the plug-in PSU

Adapter and remove the plug from the DC power

socket in the Control Panel.

Remove either back-up battery and disconnect

the battery leads

5. Set jumper link P1 to the ON position.

Reconnect the battery leads and replace the

back-up battery in position.

Reconnect the PSU Adapter plug to the DC power

socket in the Control Panel and switch On the

supply to the PSU Adaptor

As the Control Panel powers-up, ‘EEPROM

RESET’ will be displayed while the factory

default conditions are restored to memory.

Once the memory reset has been completed

‘DISARM READY’ will be displayed. The Control

Panel will now be reconfigured with all factory

default settings

8. Reset jumper link P1 into the OFF position.

9. Close the Control Panel cover and refit the fixing

screws.

User Access Code

Jumper

Link P1

OFF ON

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

Pas de commentaire

Response SA5 E Instructions d'exploitation Page 21