Response SC379 Manuel d'utilisateur télécharger pdf (Page 4)

Installation

■ Battery Installation

Bell Push

The Bell Push is operated by 1 x 3volt CR2032

Lithium battery (included)

The Lithium battery (CR2032) has been installed.

To activate the battery remove the battery cover by inserting a small

flat-bladed screwdriver into the recess and push the battery cover

forward. Remove the isolation strip from the battery compartment,

then snap the cover back on. The Bell Push is now ready to use.

Bell Push battery replacement

Follow the instructions above to remove the battery cover and replace

the battery with 1 x 3volt CR2032 Lithium battery. Ensure the battery

polarity matches the internal markings (“+” face upward). Press the

battery down so that it is sitting firmly in its compartment. Snap the

back cover of Bell Push back on.

1 2 3 4 5 6 7 8 9 ... 15 16

Pas de commentaire

Response SC379 Manuel d'utilisateur Page 4